This stand is better than the aftermarket stand I purchased after lowering my bike. This stand was compatible with the switch that turns off the engine when I deploy the stand. The lean angle gives me comfort that the bike will not fall over in either direction.
View Detail
- Instock
917.91 NOK (13,270 JPY)
Webike Point: +133 pt
(9.19 NOK)
Leveringsinformasjon
In Stock : 5 left, Ships within 24 hours.
Estimated arrival date around
Produktbeskrivelse under automatisk oversette av Google.
Produkt detalj
[Mengde]
· 1 stk.
[Sammenlignet med standard]
・-20mm
** Vær oppmerksom på at produktspesifikasjoner kan endre seg på grunn av produsentens årsaker..
Kort TypeSide-stativ for å eliminere den ustabile tilstanden på grunn av at karosseriet står for høyt under Lowdown-tilpasset.
Designet og kragen er det samme som Standard, og bildet av kroppen er ikke skadet.
Forsiktighet
* If there may be an instruction manual included, it will be written in Japanese.
MODEL PAGE LINKS
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
New arrivals in used
New arrivals in used
Kunde anmeldelser
Reviews with image
Fits:KAWASAKI , KAWASAKI
Installed on: KAWASAKI Z900RS CAFE
Fits:KAWASAKI , KAWASAKI
Jul 29, 2022
색도 순정과 비슷해 진짜 만족합니다. 하지만 한가지 불만족인 부분은 토크값이 높아서 힘이 없으면 하기 힘들것이라는 것입니다.----------------------------------------------------------The colors are similar to pure, so I am really satisfied. However, one dissatisfaction is that the torque is high and it will be hard to do without power.Powered by Google Translator
View Detail
Helpful?
Fits:KAWASAKI , KAWASAKI
Nov 1, 2020
When 2cmLowdownRear suspension link was put in Z900RS, it was the case that there was no problem at all even with Side Stand of NORMAL especially, but the Caster of Front was made to stand. (Front fork protrusion amount is 25mm out from NORMAL) Of course, I thought about the reliability and cost performance. It was easy to remove the bolt, nut, and collar after removing the spring with the STAND raised. It was easy to replace the bolt, nut and collar. Today, I changed the mounting bolt to 64Titanium, and I used NORMAL because Nut is a special Nut with a thin stopper.
I think PMC can make TitaniumParts that we can afford.
Please do your best. I'm rooting for you.
Helpful?
New Custom Articles
