Svart deksel Vannmotstandslys for toppsak Utstyrt kjøretøy 4L

Every time I think of Motorcycle Cover, I buy this.
It will deteriorate in 3-4 years, but buying this one is a whole lot better than buying a cheap one.
Water-repellent spray temporarily revives it, but I decided to replace the stones.
I'm going to use it as long as possible by stacking two layers, one new and one old.
It is too bulky to carry around as a quicksilver, but I don't expect it to be used for that purpose, so it's not a problem.

DL1000 V-STROM1050XT with GIVI's Top case (DLM30) It's not too large, not too small, but just right.
The fabric isn't very thick so I'm not sure how durable it is, but I'm hoping it will last at least 3 years, and if it lasts 5 years I'd give it 5 stars, but I park in a lot of places where the back of the car juts out from the roof, so I'm not sure if that's a good thing.
It is difficult to stick the heat-resistant seal that attaches to the Exhaust System part.
Other than that, I am generally satisfied.

OEMScreen, OEMPannier&Top case on a 2016 FJR1300AS.
The size is just right with it on. The subtle point is that the Cover
At the bottom, the part that touches the ground, there is a string for the squeeze, but I think it is a little thin. I guess it's not the part that I care about so much.

Large type Adventure (Leaning) I use it on my Motorcycle and VFR800X.
I park my bike at the bike parking lot in Apart, and since it faces Large Street and is visible to people, I bought it in a darker color to prevent theft and tampering.

[How is it used?

I've been using it for 3 months with no problems.

Was the one you received as per Image?

It was just as Image.
The texture is solid and you won't have any problems with Small stones or branches flying around a bit in the wind.

How was your experience with it?

The size is Large, so it is a little difficult to handle.
In order to correspond to the box, the back part is also large, and it is difficult to understand the front and back at first glance.
The mirror part is a little wider and has a structure like a vent hole, so look for it.

It's really not good, but there was no problem even if I put the exhaust system which became hot to the penis just after running. If you use a cheap non-flameproof one, a tragedy will happen. (Actual experience) 。

It has a buckle under the belly that can be pushed and fixed.

Top case installed. =Side case is not expected, but for VFR800X, any product will probably fit perfectly in full pannier condition.

By the way, the Size of the VFR800X is as follows.
Overall length:2,190mm
Overall width:870mm
Overall height:1,385mm
(From HONDA official:https://www.honda.co.jp/VFR800X/spec/)

In full pannier condition, the front length is about +15cm and the rear width is Quantity.:Pair (for Left and Right) Total +60cm or so? It increases, so it's all about that.

[Points to note]

If it's too large, it will flap around and get in the way, or it will be troublesome to wear, or it will cause wound, so choose the best size.
This 4L also had an extra Large width in the back when I put this Cover on without the Rear box.

How did it compare to other products?

I used to use a cheap Cover for Rebel 250, but I didn't like the SmallWound and the fact that it was too thin and floppy.
There are many more Motorcycle Covers out there, but for Size and ease of storage, this is the product for me.

Other items that would be helpful

I heard somewhere before that the best way to prevent theft is to not show your motorcycle to the other person.

It is a Motorcycle of this size. It is not possible to load it on the truck.
Thieves, for example, make preparations in advance by casing the area, defining the objects, and making calculations.
I think it's important not to show it first.

Also, at night, there are drunk people walking around and throwing up Tan, and someone with bad intentions is going around receiving Wound. In order to protect from them, this kind of Cover is indispensable.

It's only a Cover, but it's still a Cover.

I bought this for my XJ6N with 30LTop case (OEM Carrier).
I bought the 4L to have more room, but the 3L might have been fine.
However, thanks to the large crevice size, installation work can be done rather smoothly.
I'm satisfied because I can use Cover with Top case on.