LED Headlight Kit 12V Universal Universal

Because it was cheap at the Sale where I thought that I wanted to replace because it is dark, it was installed as a Normal valve, so it was installed.
It is much brighter than Normal valve but high beams can not be used as you are told, so you should be careful for those who frequently use High beam.

Visibility became visible as Clearly widely when driving at night.

Regarding installation, as is also found in the conformance table, two Screws interfere.
In my case I scratched Screw's head instead of Grom Body side and made it Flat.
Since it interferes so as to block the Vent hole unless the hole of the existing RubberCup is also widened, we recommend that you process it.

Because Wiring is short, I installed the installation in Case.
Well of High beam - - - It is a decoration w

I wanted to make Headlight LED, I installed Kit here.
Adaptation to GROM 【Installation】 : △, lighting : △] and it is,
Mounting : △ -> Because the Screw of the LED Bulb interferes, it is necessary to slightly cut the mounting portion on the GROM side
Lighting up : Flickering may occur when Δ -> High beam is selected
And attention was written.

Although Screw certainly interferes with Headlight case at the time of LED installation, installation can be done even if there is no machining. (I did not know until the optical axis was affected)
High beam also had some flicker, but it was not enough to worry.
Low beam is not a problem at all.

Because the interference of Screw and the installation of LED Controller is troubled, the installation evaluation was set to 3
There is no problem with other performance.

Although it is a personal impression, it was not so, as if the light intensity dramatically increased from Halogen.
It seems better to wear it thought of as Dress-up.

Originally Halogen was a mountain of the night and I was scared of lack of brightness so I tried to replace it with led.
LampUnit is a little big, so I'm working from the side of Fork, but it took quite some time. Let's not touch its lightest Valve part with bare hands. Lifespan shrinks with finger sebum.
The impression that I used was easy and easy to see with white light, because the diffusion of light is wide, and the mountains of the night got more sense of security as it is very bright above all! The optical axis of the high beam was also perfect on the straight side just fine.
After all led is good.

I ordered around 2:30 pm and arrived the next day. I think that it is quick and good.
When NORMAL 's Valve was 11,000 km, we exchanged it with an OEM, now we have reached 23,000 km and it approached the timing of replacement so we made it LED Bulb.
Well, the installation of the product was easy to install on the corner SuperCUB 110 without any problems.
I rarely run at night usually, but I tried running. At the beginning I seemed to be pretty lighting in the foreground, but I think that I only saw that because the whole is bright. I think that raising the optical axis here will cause annoyance to oncoming vehicles. With this you can also use High beam well.
Then I tried running in the daytime but the number of cars coming out forcefully from the alley became less. This is my favorite place.