- [How is it used?Installed on st250eType in reverse orientation.Was the one you received as per Image?As per ImageWas the installation difficult?I asked Shop to do it for me, but I don't think it is di...Les mer
- I wanted to make it look like a separate handle easily, so I reverse-attached it.Since it interferes with the tank, I purchased a separate Handlebar Stopper and adjusted the angle to avoid fatigue.It ...Les mer
- About Pin for Switch box 。 On the Left (Blinker) side, it is enough to measure the distance of the hole from the end of the STD Handlebar, but on the Right (Kill switch) side, the switch box is Large,...Les mer
- With the OEMHandlebar, my arms were open and I was leaning forward halfway, and after an hour my arms were numb and my back was a little sore, but this has improved!The position of the brake lever is ...Les mer
- I used it on my SR400. I found a custom method to make this handlebar upside down and make it look like a sepahan, so I tried it. I think there are many other reference for how to do it, so I'm just t...Les mer
- I referred to Net's impressions before purchasing. It did not interfere with the Tank as most people wrote. I asked a motorcycle shop to install it because I was not confident in the handling of the C...Les mer
- The Handlebar is squeezed for better control. This is a recommendation because of its low price.Les mer
- The V7?OEMPipe Handlebar is wide and has a shallow aperture for Europeans, and my shoulder hurts when I ride it, etc. I was thinking of replacing it from early on. "V7?Racer. The OEMSeparate Handlebar...Les mer
- We were able to install it without changing the wires.It is easy to cut the Handlebar at a good angle.Naturally, this is not a product exclusive to any vehicle, so you will need to drill holes to fix ...Les mer
- Position is now easierIt took me a while to install it, but I managed to do it.The weld spatter at the bottom of the weld was painted without finishing it.It looks very bad in that area.Whenever you h...Les mer
- I received the product and decided not to use the SWCondor because I felt that the current Posh Conti was somehow better.Les mer
- I replaced it from this Fat bar attached to Buell X1 to this Handlebar, the angle is just slightly larger than the normal Condor Handle, but it is just right, because the height was low, make the Bolt...Les mer
- I wanted to make DUKE 's Handlebar a bit more Sporty, but in normal Condor the Handlebar width is too narrow to handle Handlebar LockWith this SW, Clearance of Tank and Handlebar is also Limit, ma...Les mer
- I asked Motorcycle shop and asked the SR 400 to reverse it!There is no interference of switches and Handlebar Lock is also possible.It was good as Position could be lowered at a low price.Les mer
- My motorcycle (CB400SB) Because it did not attach to, I gave it to my acquaintance, but Quantity : Pair (for Left and Right) Hitoshi etc. It seems there is no stick on it, because it is a weld, angle ...Les mer
- If it is a SW condor handle, it is impossible, because I thought that it would manage somehow, because I installed a radiapon brake.After steering wheel turn, automatic brake. I do not want to return ...Les mer
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING