I had an SRL installed on my NeoTEC2.
Because the time of use was short and Attachment was released, it was changed to SB6X. I was a little uneasy about the installation with Double-sided Tape
[How is it used?
I bought this product because I needed to replace the B com I had been using with a new helmet, GT Air II.
I have not tried to install it without Attachment, but I think it is worth buying.
Was the one you received as per Image?
As shown in the Image. No disappointing points.
How was your experience with it?
It's very nice.
The attachment is adhesive Tape, but it is Firmly fixed using very strong 3M.
The trial period is still short, so it is unclear how well the adhesiveness will be maintained, but as long as one does not try to pull it off with extreme force, there seems to be no problem.
I use Base plate all the time, but I think I could have bought a new one when I bought this product.
[Points to note]
The base plate should be carefully positioned....
If you put it on properly, the position of the Body will not be good, and it is not recommended to reapply it.
[Overall impression.
Overall, I am happy with my purchase.
The price is not too expensive! It's not that expensive, so I'll replace it when it goes bad.View Detail
I used it on my new B+com PLAY.
The Helmet is GT-AIR2, and using the Attachment, I was able to install it with good balance.
It would be nice and convenient to have, but if this is all the parts you have, I would like you to offer them at a lower price.View Detail
Income used to use SENA SRL2 dedicated to GT-AIR2, but since the income of motorcycle riders around me was switched to B+COM due to the high rate of use of B+COM, I purchased this dedicated Base. The position where the Body is attached is also exquisite, and I was able to operate the Income with the Gloves on, put in and out of the Antennas, and use the Antennas. The position where the Body is attached is also exquisite, and it was possible to operate the Income, Antennas, Sun visor, etc. with no discomfort while wearing the Gloves. I tried to install the B+COM's base with wire fixation before installing this special base, but the impression was quite severe. I have not tried it, but it might be better to use this Base for some income other than B+COM.View Detail
I bought a new Helmet, so I bought it for relocating B+com along with the new Helmet.
Since 3M's double-sided tape is used, it can be degreased properly.
If you let it sit for 24 hours, it will stick Firmly.View Detail
Bought B+COM ONE to install on SHOEI's JCruise?. SENNA is expensive, so I think B+COM is sufficient.View Detail
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING