Det er et tredimensjonalt emblem som kan festes til drivstofftank, sidedeksel. Som ett punkt vedlegg.
Kroppen har Materiale: Plast er adoptert, Plating brukes på overflaten av tegndelen.
Emblem Dobbeltsidig tape for sterk eksteriør limes på baksiden.
Det er to typer Plating: Silver og Gold, to typer LargeSmall er tildelt hver mengde: 2pc. Angitt med fire, totalt antall: 1 Sett.
[Annonsevisning]
Vi adoptere sterk vedheftssete, så sjekk stillingen godt før du legger inn arbeidet.
Hvis fuktighet, olje, støv og voks er tilstede, vil adhesjonen være ekstremt dårlig, så vær så snill å rengjøre og avfette adhesjonsflatene grundig.
Miljø med lav omgivelsestemperatur (5 grader eller mindre) For å styrke den første adhesjonskraften, vær så snill å jobbe etter litt oppvarming av limet.
Etter liming, vennligst trykk godt fra toppen for å styrke vedheft. Vask ikke eller regn i løpet av 1 eller 2 dager etter liming.
This is a three-dimensional emblem that can be attached to the gas tank, side cover, etc. as a one-point accessory.
The body is made of plastic, and the surface of the letters is plated.
Strong exterior double-sided tape is attached to the back of the emblem.
Plating is available in silver and gold.Two large and two small, total 4 pieces per set.
[Advice]
The strong adhesive sheet is used, so please check the position of the adhesive sheet carefully before installation.
If there is water, oil, dust, or wax on the surface, the adhesive strength will become extremely poor, so be sure to thoroughly clean and degrease the adhesive surface.
When working in a low temperature environment (below 5 degrees Celsius), warm up the adhesive sheet a little before working in order to strengthen the initial adhesive strength.
After pasting, please press well from the top to strengthen the adhesive force.Please do not wash your car or drive in the rain for 1 or 2 days after application.