Excellent
The tiredness of the arm makes considerably easy.Bolt RSpecifications attached to ABS.
I think I just came in front of you, but even with that alone pretty much the posture itself became easier.
I have not installed it yet, so I am not riding long distances, but I am likely to reduce the tiredness of my arms.
This time, I tried my best and I challenged to install.
Since there is no Instruction Manual, I removed it while watching the Service Manual but as I tried following the Service Manual, "You did not have to get off that far ..." There were some parts called.
Manual In order as described,
■ Removing Headlight. Horizontal screws (3. 8Nm)Quantity : Remove Lens with 2pc. Two couplers inside, disconnect, screw (7Nm) Remove all with 3. ... It seems that Headlight does not need to be removed. If there is any trouble with the removal after this please remove.
■ Removing Back Mirror. ? ? ? It is possible to do without doing this, but it is worried about dropping and scratching so it is better to remove them. As Yamaha, please note that Right's Mirror is reverse threaded.
■ Front brakeLightSwitch connector removed. Quantity under Brake master cylinder : 2pc Connector. You can pull it out. ? ? ? It seems that even without doing this.
■Front brakes master cylinderHolder. Quantity : 2pc screw (10Nm) It will be out.
■RightHandlebar switch. Quantity : 2 pc screw (3. 5 Nm) Open with spur. In the Manual, you will also remove the Throttle Cable, but leave it as it is below (Other than Handlebar grip) It is best to remove as it is after removing.
■Clutch switchCoupler. Coupler disconnect under LeftHandlebar switch.
■LeftHandlebar switch. Quantity : 2 pc screw (3. 5 Nm) Open it up and remove it.
■Handlebar grip. This is an idiot. It is hard to get out. It is postponement.. After removing all other parts, I tried and errored carefully. In Manual "Blowing compressed air into the gap" Although it is written, since there is no Compressor, in the end, I rolled off from the edge and removed it with power while making it into a Doughnut shape. I feel this is the best. It's a quite resilient Rubber.
■Clutch Cable - Clutch lever. If you do not remove it, RightHandlebar will not come out. Remove the Clutch lever while removing it.
■Clutch switch. ? ? ? It is not removed.
■Clutch lever holder. One screw in front (10Nm). After removing the Handlebar grip, remove it.
■MeterAss'yBracket. Meter got in the way, Upper Handlebar holder (Main's Handlebar fixed Bolt near Center) Because you can not remove the screw of the Meter bottom screw (7Nm) Quantity : Remove only 2 pc so we can shift Meter. Protect Tank across Cushion.
■ Upper Handlebar Holder 2 places. screw (28Nm) Total 4.
Now that you can remove the Handlebar. Unplug the Right Handlebar Throttle, remove the Left Handbar grip and remove the Clutch lever holder.
The above is the removal procedure, "It does not have to be removed" Even if I wrote it, perhaps it might interfere with others, so please remove it then.
And install this Handlebar of HURRICANE in the reverse order of removal.
I forgot to take a picture. Although there is no picture,
Those who are aiming for DIY, please do their best..
View Detail